10
20V Cordless Crown Stapler
EN
NOISE INFORMATION
A weighted sound pressure L
pA
= 75 dB(A)
A weighted sound power L
wA
= 86 dB(A)
K
pA
&K
wA
3 dB(A)
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 60745:
Vibration emission
value:
a
h
= 3.58 m/s
2
Uncertainty K = 1.5 m/s
The declared vibration total value may be used for comparing
one tool with another, and may also be used in a preliminary
assessment of exposure.
WARNING The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool is
used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed.
WARNING To be accurate, an estimation of exposure
level in the actual conditions of use should also take
account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle but
not actually doing the job. This may significantly reduce the
exposure level over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions and
keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti vibration
accessories.
Plan your work schedule to spread any high vibration tool use
across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended Use
This tool is intended for nailing decoration of board line,
skirting line and wooden frame, etc.
WARNING Do not point the nail gun to people or
animals. Always remove the nails and the
battery pack when not using the tool.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Removing the battery pack See Fig. A1
Charging the battery pack See Fig. A2
Installing the battery pack See Fig. A3
ASSEMBLY
Installing the belt hook See Fig. B
Loading the brad nails/crown
staples
NOTE: Keep pressing the magazine
release button when opening or
closing the magazine.
WARNING Keep the tool
pointed away from yourself
and others when loading nails.
Failure to do so could result in
possible serious personal injury.
See Fig. C1, C2
OPERATION
Drive depth adjustment
Rotate the depth adjustment knob
clockwise to increase the drive
force.
NOTE Drive a test nail after each
adjustment until the desired depth
is set.
See Fig. D1
Drive force indicator See Fig. D2
Start the stapler
Press the contact against the
surface, then press the switch
trigger to start the machine.
See Fig. E
To Next Page
Loading...
