16
guarD MODE
Put Roboreptile into Guard Mode to watch over the area
immediately around him.
Guard Mode In layer 2
He will get up on his back legs and become stationary. He will
then use his Infrared Vision Sensors and Sonic Sound Sensors
to guard the area immediately around him.
If he hears a sound or sees movement he will either
A perform a default animation
B perform a user programmed routine (if one is programmed)
After about 20 minutes he will power down.
To exit Guard Mode press ANY button.
CAUTION
Do not put Roboreptile near the edge of a table since he could fall off when
becoming animated.
Roboreptile’s volume can be adjusted using the Volume
Control function. When he is powered ON his default
volume setting is High.
Volume Up In layer 2
Volume Down In layer 2
There are three volume settings
1 High
2 Low
3 Mute
NOTE
Altering the volume when Roboreptile is performing
a function will cause the function to stop.
vOLuME COntrOL
To Next Page
Loading...
