WP XACT PRO 7548 - Service Work on the Chassis; Raising Motorcycle with Lift Stand; Removing Standard Fork Legs; Installing WP PRO COMPONENTS Fork Legs

SERVICE WORK ON THE CHASSIS 8
11
8.1 Raising the motorcycle with a lift stand
Note
Danger of damage The parked vehicle can roll away or fall over.
– Park the vehicle on a firm and level surface.
401942-01
– Raise the motorcycle in accordance with the instructions of
the vehicle manufacturer.
Neither wheel is in contact with the ground.
– Secure the motorcycle against falling over.
8.2 Removing standard fork legs
H03150-10
– Remove the standard fork legs as per the instructions of the
vehicle manufacturer.
8.3 Installing the WP PRO COMPONENTS fork legs
H03317-10
– Install the fork legs in accordance with the instructions of the
vehicle manufacturer.
Guideline
Observe the installation position of the milled grooves to
the upper edge of the upper triple clamp.
125/150 SX EU,
TC 125/150 EU
3rd groove from the top
remaining EU versions 2nd groove from the top
all US versions 2nd groove from the top
Bleeder screws
1
are positioned toward the front.