TUNING THE CHASSIS 9
15
H03144-10
–
Turn adjusting screws
1
clockwise up to the last percepti-
ble click.
Info
The adjusting screws are located at the top end of the
fork legs.
Make the same adjustment on both fork legs.
A screwdriver is shown for better illustration, an
adjustment tool is included in the scope of delivery.
– Turn counterclockwise by the number of clicks correspond-
ing to the fork type.
Guideline
Compression damping
125/150/250 SX EU
TC 125/150/250 EU
19 clicks
250/350/450 SX‑F EU,
350 SX‑F US
FC 250/350/450 EU,
FC 350 US
14 clicks
125/250 SX US,
250/450 SX‑F US
TC 125/250 US,
FC 250/450 US
12 clicks
Info
Turn clockwise to increase damping; turn counter-
clockwise to reduce damping.
9.4 Adjusting the rebound damping of the fork
Info
The hydraulic rebound damping determines the fork suspension behavior.
H03145-10
–
Take off protection caps
1
.
–
Turn adjusting screws
2
clockwise up to the last percepti-
ble click.
Info
The adjusting screws are located at the bottom end of
the fork legs.
Make the same adjustment on both fork legs.
– Turn counterclockwise by the number of clicks correspond-
ing to the fork type.
To Next Page
Loading...