WPS pro - User Manual

To Next Page

Have a question? Let us know and we will help.

Email: support@wirelesspyro.co.uk

Phone: +44 (0) 7842 783136

WPS pro quick setup guide

WPS pro module has two external antennas – one for radio module and one for

GPS receiver.

Use XLR breakout harness to connect via 2-wire communication or external

trigger input.

Connect red end of the CAT5 cable to WPS pro and yellow to WPS slat(s).

If you are not using WPS high quality CAT5

cables - please remove the clip on the end of

plug where WPS pro is to be connected for

easier connect/disconnect.

Plug the LiPo charger into the Power jack on the panel for easy charging. Once

plugged in, charger indicator light will turn red. Light on the charger will turn

green once battery has been fully charged.

Note: For safety reasons do not leave charging unatended. For long term

storage discharge battery slightly for longetivity of LiPo battery. See User

Manual section 3.1 for more details.

Need help?

Do you have a question about the WPS pro and is the answer not in the manual?

WPS pro Specifications

General

Describes the two external antennas for the radio module and GPS receiver.

Connects via 2-wire communication or external trigger input using an XLR breakout harness.

Connects the red end of the CAT5 cable to WPS pro and yellow to WPS slat(s).

Instructions for connecting the LiPo charger and safety notes for unattended charging.

Describes the two external antennas for the radio module and GPS receiver.

Connects via 2-wire communication or external trigger input using a 3.5mm breakout harness.

Instructions for charging the WPS mote using a mini USB cable and charging indicator.