WRIGHT STANDER X 79490219 - Default Chapter; Table of Contents

ii
Table of Contents
1 INTRODUCTION ........................................................ 1-1
2 NEW MACHINE SETUP ............................................. 2-1
3 SAFETY PRECAUTIONS ........................................... 3-1
Important .................................................................. 3-1
Safety features ......................................................... 3-1
Training .................................................................... 3-1
Preparation .............................................................. 3-1
Operating ................................................................. 3-2
Slope Specic .......................................................... 3-3
Children Specic ...................................................... 3-3
Fire and Fuel Specic .............................................. 3-3
Service ..................................................................... 3-4
4 MACHINE OVERVIEW ................................................ 4-1
Specications ........................................................... 4-1
Engine
Electrical System
Drive System
Hydro Oil System
Fuel System
Speeds
General Dimensions
Torque Specications
Safety Interlock System ........................................... 4-1
Digital Hour Meter .................................................... 4-1
Deck Lift ................................................................... 4-2
Machine Features .................................................... 4-2
Overview
Operator Area
Control Panel/ Steering Levers
Warning, Safety, and Instructional Decals ............... 4-3
Pictogram Meanings ................................................ 4-3
5 OPERATION ............................................................... 5-1
Adding Fuel .............................................................. 5-1
Fueling ..................................................................... 5-1
Starting the Machine ................................................ 5-1
Driving the Machine: ................................................ 5-2
Operating the Blade Switch (PTO) .....................5-2
Operating the Operator Presence Control (OPC)
Switch ...................................................................... 5-2
How to Stop and Park the Machine ......................... 5-2
Driving the Machine Over a Curb ............................. 5-2
Mowing on Varying Terrain ....................................... 5-3
Facing Uphill
Facing Downhill
Crossing a Slope Sideways
6 SERVICE AND MAINTENANCE ................................ 6-1
How to Adjust Neutral .............................................. 6-1
Speed/Sensitivity ..................................................... 6-1
Check and Adjust Tracking ...................................... 6-1
Check Machine Tracking
Adjust Machine Tracking
Reaching Maximum Capable Speed
Tire Maintenance and Pressure .............................. 6-1
Troubleshoot No-Start Condition .............................. 6-2
Moving the Mower if it won’t Start ............................ 6-2
Troubleshoot No-PTO Condition .............................. 6-2
Height of Cut ............................................................ 6-2
Cut Setting Recommendations
Recommended Mowing Heights
Troubleshooting Cut Quality ..................................... 6-3
Belt Adjustment/Replacement .................................. 6-3
Replacing the Cutter Deck Belt
Replacing the Drive Belt
To Install a New Belt:
Hydraulic System ..................................................... 6-4
Bleeding Air from the Hydraulic System
Checking oil
Filling oil
Changing Oil
Fuel Evaporation System ......................................... 6-4
Lubrication ............................................................... 6-4
Parking Brake Adjustment ........................................ 6-5
Spindle/Drive Pulley R&R ........................................ 6-5
Cutting Blades .......................................................... 6-5
Battery Service ......................................................... 6-5
Cleaning the Machine .............................................. 6-5
Engine Manual / Maintenance ................................. 6-6
Maintenance Interval Chart ...................................... 6-6
Daily Visual
After 8hrs
Every 100hrs
Every 300hrs
Every 500hrs or Annually/Oseason
Maintenance Record ................................................ 6-6
7 WRIGHT MANUFACTURING, INC. POWER
EQUIPMENT LIMITED WARRANTY .............................. 7-1
8 FEDERAL AND CALIFORNIA EMISSION CONTROL
WARRANTY STATEMENT ............................................. 8-1