8__[Y^WE`dXUD" %
!$ =_TYVYUT*' ! ! ! DUSX^Ydb_^D" % GU \T3_^db_\
Check at various percentages, making sure the control does not
go over range at high percentages. A control in over range will
"top out", displaying a value and then beome unable to display
any higher values. Record the tap setting, turns ratio and good
weld current value. Then in CC mode (SW1-1 closed), requesting
the same current observed in AVC mode will result in that
current maintained constantly.
To Next Page
Loading...
