WUBEN E01 Instruction Manual

Turn on: Single click on the tail switch to turn on the light
Outputs selection: When the light is on, tap on tail switch
to cycle through Low-Med-High, and click to turn it off.
Flash mode: When the light is off, double click on the
switch to get into SOS, click again to get out.
3. Operation
When battery in low status, flashlight will shift down the
brightness automatically until battery totally die.
3. Low battery status indication
FL1 Standard
Size
100 Lm
40 m
395 cd
1 m
IP68
20 Lm 1 Lm
1 h
5 h
20 h
20 Lm
/
High Med Low SOS
82.5mm x 15mm ( L x D )
We recommend only a WUBEN brand battery.
Charge or replace the battery when the power is low.
Clean the battery contact points with alcohol and wipe
clean as necessary.
When not in use we recommend removing the battery
for safe storage.
O ring may lose its effectiveness over time and need
to be replaced with the spare O ring to ensure the
flashlights water resistance.
Maintenance
Parameters
The above data tested in WUBEN laboratory, may fluctuate due to
a variation in the testing instruments.

WUBEN E01 Specifications

General

Brand	WUBEN
Model	E01
Category	Flashlight
Language	English