9
Product Specifications
Intended Use
The cordless drill/screwdriver can be used for drilling
wood, metal and plastics and also as a screw driver.
For damage caused by usage other then intended, the
user is responsible.
Battery Charging
The battery is equipped with an NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and +50 °C. A long battery
service life is achieved in this manner.
Maintenance and Care
Always remove battery before working on machine.
❏
Always keep the machine and the ventilation slots
clean.
If the machine should fail despite the care taken in man-
ufacturing and testing, repair should be carried out by
a Würth Master-Service agent.
For all correspondence and spare parts orders, always
include the article number on the type plate of the ma-
chine.
For the current spare parts list of this machine, log into
the Internet under “http://www.wuerth.com/partsman-
ager” or ask for a copy at your nearest Würth branch
office.
Disposal
Power tools, accessories and packaging should be sort-
ed for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment and its in-
corporation into national law, power tools that are no
longer suitable for use must be separately collected and
sent for recovery in an environmental-friendly manner.
Defective or worn out batteries must be recycled ac-
cording to the guidelines 91/157/EEC.
Warranty
For this Würth machine, we provide a warranty in ac-
cordance with statutory/country-specific regulations
from the date of purchase (proof of purchase by invoice
or delivery note). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or im-
proper handling is excluded from the warranty.
Claims can be accepted only when the machine is pre-
sented undisassembled to a Würth branch office or a
Würth field service employee.
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 60 745, EN 55 014,
EN 61 000, EN 50 366 according to the provisions of
the regulations 73/23/EEC, 89/336/EEC,
98/37/EC.
06
Adolf Würth GmbH & Co. KG
P. Zürn R. Bauer
Battery-operated
Screw driving drill BS 96-A solid
Part number 0700 182 X
Rated power 300 W
No-load speed
Speed I 0–300 rpm
Speed II 0–1000 rpm
max. torque 27 Nm
Drill dia. Steel 10 mm
Drill dia. Aluminium 10 mm
Drill dia. Wood 20 mm
Screw dia. 6 mm
Thread of work spindle 3/8" - 24 UNF
Weight approx. (without Battery) 1.24 kg
Battery (SD)
Part number 0700 980 3..
Subject to change without notice
BS 96A_solid.book Seite 9 Montag, 11. Dezember 2006 1:21 13
To Next Page
Loading...
