12
Legend
Explanation of pictograms
Lamps with limited surface temperature
Compliance with EU directives
Electronic scrap (WEEE directive)
Permitted in difcult conditions
Protection classII
Maintenance / care
Attention!
Clean the device only when the mains
plug has been removed.
■ Clean the lamp with hot water, or if necessary
with a standard detergent.
Do not use any technical solvents, acetone,
benzene, tetrachloromethane, etc.
■ Likewise, do not leave in contact with oils or
grease for long periods.
■ Adamaged lead may only be exchanged
by the manufacturer or an authorised service
company.
Environmental instructions
Do not dispose of this device with
household waste. Dispose of the
device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
waste disposal facility. Dispose of all
packaging in an environmentally compatible
manner.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specic regulations (proof of purchase
through invoice or delivery note).
Damage that has occurred will be corrected either
by replacement or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims can only be acknowledged, if the device
is transferred fully non-disassembled to a Würth
agency, your Würth sales representative or a Würth
authorized customer service ofce.
Subject to technical changes without prior notice.
We accept no liability for printing errors.
Spare parts
If in spite of careful manufacturing and test proce-
dures, the device becomes faulty, a repair by Würth
masterService should be arranged.
With any enquiries or spare parts orders, always
quote the item number as given on the device type
plate.
To Next Page
Loading...
Need help?
General
