Seite 12 von 100
2.4.3 SPECIAL CASES “JOIN”
In case both instruments are already joined in different groups of instruments they do find each other but they can not
communicate together. The red LED “OFF” is blinking. The search process may be cancelled by using the key
<ON/MODE> or <ENTER>
If it is required to use one of the instruments in the new measurement group it is necessary to use the mode “LEAVE” to
cancel the existing connection.
2.5 UNHINGE AN INSTRUMENT IN THE RADIO MODE FROM A GROUP BY USING THE FUNCTION „LEAVE“
Each instrument may be unhinged from an existing group of connected instruments.
PROCEDURE „LEAVE“
1. If BlueLEVEL instruments are transmitting measuring
values to a BlueMETER or a BlueTC, the keys on the
BlueLEVELs are locked. To unlock a BlueLEVEL, the
settings at the BlueMETER have to be changed in such
a way it no longer communicates with this BlueLEVEL.
2. The instruments to be disconnected must be set to the
mode LEAVE. The <ON/MODE> key must repeatedly be pressed until in the display shows the mode [LEAVE].
Confirm with <ENTER>
3. During the leaving mode the blue LED is blinking under “LINK”, the green LED “READY” is not blinking
respectively off.
4. After the successful procedure the green LED is blinking once for approx. 1 second. With this the unhinge
process is finished.
2.6 RENEWED CONNECTION OF A MEASURING GROUP
After a measuring group has been stopped e.g. after the termination of a measurement, the group of instruments
remains intact. After the restart the communication is automatically activated and the communication is started. The
process JOIN must not be repeated.
To Next Page
Loading...
