Seite 7 von 100
2 PREPARATION AND START-UP OF THE MEASURING INSTRUMENTS BEFORE STARTING
2.1 BATTERIES
The batteries are not installed in the new instruments they are delivered separately. It is recommended to remove the
batteries when transporting the instruments.
2.1.1 INSERTING RESPECTIVELY REPLACEMENT OF BATTERIES IN BLUELEVEL
The status of the battery power is displayed e.g. 2
7
(2, 7 Volt)
The lowest voltage is 1, 7 Volt. After this limit has been reached a battery symbol blinking is displayed.
When the „ “symbol is blinking the batteries should be replaced.
2 pieces 1.5V, Size “C” ALKALINE
2.1.2 INSERTING RESPECTIVELY REPLACEMENT OF BATTERIES IN BLUEMETER
3 pieces 1.5V, Size “C” ALKALINE
2.1.3 INSERTING RESPECTIVELY REPLACEMENT OF BATTERIES IN BLUETC
2 pieces 1.5V, Size “C” ALKALINE
To Next Page
Loading...
