Wyrestorm EXF-300-H2

To Next Page

To Previous Page

EXF-300-H2 Quickstart Guide | 180516

UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)

support@wyrestorm.com

3 of 4

EDID Conguration

This extender uses EDID pass-through from the display to the source. No conguration is required for EDID settings.

Setup and Conguration

RS-232/IR Over Fiber

The EXF-300-H2 can transmit RS-232 or IR over ber bidirectionally, however it

can only send one or the other. The following settings must be made on both

the TX and RX for the type of signal that will be sent within the installation.

Send and Receive RS-232

Send and Receive IR

Troubleshooting

No or Poor-Quality Picture (snow or noisy image)

• Verify that power is being supplied to the transmitter and receiver.

• Verify that the ber cable is properly terminated.

• Verify that the output resolution of the source and display is supported by

this extender.

• If transmitting 3D or 4K, verify that the HDMI cables used are 3D or 4K rated.

• Verify that all source and ber connections are not loose and are functioning

properly.

No or Intermittent 3rd party Device Control

• Verify that the RS-232/Ethernet cables are properly terminated.

• Verify that emitters/receivers are compatible with WyreStorm IR.

• If using an IR control system, verify that it is connected using the CAB-IR-

LINK cable.

Wyrestorm EXF-300-H2 - Page 3