8
FOOTREST ADJUSTMENT
Press the buttons on both sides of footrest and adjust it to the required position.
ADJUSTING THE STROLLER SEAT POSITION
Pull the lever upwards and adjust the seat to the desired position.
INCREASING THE HOOD INCLINATION ANGLE
The hood may be expanded by an additional part. In order to do this, undo the zipper
between the upper and lower part of the hood.
INSTALLING OF BUMPER BAR
Push in the ends of the bumper bar into mounting holes, until locks are snapped.
TAKING THE BUMPER BAR OFF
Push in the buttons of the guard-rail locks and slide its end out of the mounting holes.
The bumper bar may be tilted, when undone only from single side.
ATTACHING THE COVER
To attach the footcover put it under the bumper bar and attach to Velcro (a) and snap (b).
BUCKLE
To fasten the belt buckle, slide the belt lock into the slot and press it down until it snaps
into place (b). Repeat this procedure for all locks. To unfasten, press the round button
until the moment when the locks are released from the buckle latch (a).
MOUNTING THE CAR SEAT
Special adapters are needed in order to mount the baby car seat. Place the adapters
in mounting seats of the frame and attach the car seat by catching it on the adapters.
Attention: Ensure proper fitting of the armchair before using it.
REMOVING THE CAR SEAT
In order to take the car seat off, push in the unlocking pushbuttons on both its sides,
while simultaneously pulling it out of mounting seats. Remove adapters by pushing in the
unlocking pushbutton.
MOUNTING OF CARRYCOT
Special adapters are needed in order to mount the carrycot. Place the adapters in mounting
carrycot of the frame and attach the carrycot by catching it on the adapters.
DISMOUNTING OF CARRYCOT
To take the carrycot off, push in the buttons unlocking the catches (a) and pull it out from
mounting seats (b). Remove adapters by pushing in the unlocking pushbutton.
MOSQUITO NET
The mosquito net is in the pocket under the footrest (a). Place it over the footrest and
the hood (b) and then fasten the straps round the frame bars as shown in Figure (c).
LED LIGHTENING
The LED lightening is placed on the stroller frame, the switch is located on the stroller
frame in the place shown in figure (a). The place for the power batteries is in the bottom
part of the footrest (b). To install the LR 44 batteries, unscrew the bolt shown in figure
and remove the cover. The right battery assembly is presented on the cover.
ATTACHING X-BAG NURSERY BAG AND X-MUG HOLDER
X-Mug and X-Bag nursery bag can be attached to the frame using the holders shown
in the picture.
15
16
17
18
19
20
21
22
23
24
25
26
27
28
ENGLISH
To Next Page
Loading...
