7
ENGLISH
UNFOLDING THE FRAME
Unclip the linking interlock (a). Unfold the pram by lifting its handle up until the locks (b)
are engaged . WARNING: Prior to assembling the baby carriage make sure that folding
gears have been locked.
FOLDING THE FRAME
Detach the pram, seat unit or car seat from the frame. Pull the grips on the handle
upwards (a). Fold the frame holding the handle until the automatic lock is engaged
as shown in the picture(b).
ATTACHING AND DISASSEMBLY OF REAR WHEELS
To attach the wheel, press the button in the centre of the wheel and slide the wheel axle
into the mounting socket. Pull on the wheel to check that it is securely attached. In order
to remove the wheel press the button in the centre of the wheel and pull it out of the
mounting socket.
ATTACHING AND REMOVING THE FRONT WHEEL
In order to attach the wheel, slide it onto the axle until the moment you hear it lock into place.
DISMOUNTING OF FRONT WHEEL
In order to take the wheel off, push the button shown on the figure (a), and pull the wheel
off the axis (b)
WHEEL BLOCKADE
The stroller is provided with swiveling front wheels. A special button blocks the wheel
swiveling movement. After the button has been pressed, the wheels are blocked to go
straight. To release the blockade, press the lever.
PUSHBAR
Press the button in the middle of the handle and adjust its height by pulling it towards
you to lengthen it or pushing it away from you to shorten it.
BRAKE
To lock the wheels, press the brake lever in its closer part (a). To release the brake, press
the brake lever in its distant part (b).
BELT ADJUSTMENT
To adjust the belt length, move the belt towards a regulator. Regulators are hidden under
protective covers.
SHOULDER BELT ADJUSTMENT
The height of the shoulder belt position may be adjusted based on the child’s height.
To change the position, insert the regulator through appropriate holes located in the
reclining seat.
SHOPPING BASKET INSTALLATION
Fasten the snap fasteners and attach the basket to the chassis as shown in the pictures.
INSTALLING SEAT UNIT ON THE FRAME
Slide the catches of the seat unit nto mounting seats in the frame, until locks are engaged.
The seat unit can be mounted facing front or rear.
DISMOUNTING SEAT UNIT FROM THE FRAME
Push the buttons unlocking catches of seat unit in (a), then pull it out from mounting seats (b).
ASSEMBLY AND DISMANTLING OF THE CANOPY
To assemble the canopy, insert its clamps into the assembly openings (a). To remove the canopy,
press in the interlocks of clamps and bring out the canopy from assembly openings (b).
1
2
3
4
5
6
7
8
9
10
11
12
13
14
To Next Page
Loading...
