What to do if my X-Tronic 6020-PRO-X does not have power?
First, make sure the power cord of your X-Tronic Power Tool is properly plugged into the outlet. Then, check that the outlet is working correctly.
Why does the soldering iron of my X-Tronic 6020-PRO-X rattle?
The rattling sound in the soldering iron of your X-Tronic Power Tool is normal. It's caused by a small ball inside that helps the unit detect when the soldering iron is not in use, which activates the Sleep Mode.
Steps for saving and recalling custom temperature and airflow settings.
Step-by-step guide for replacing the heating element in the hot air gun.
Provides instructions on how to contact customer support for warranty service.
General| Power Consumption | 750 Watts |
|---|---|
| Voltage | AC 110V 60Hz |
| Current | ≤ 8 Amps |
| Fuse | 10 Amp |
| Power Cord Type | USA Type B - 3-Pin Grounded Plug |
| Cable Length | ≥ 33.2 in |
| Cable Material | Silicone |
| Working Environment | 32°F ~ 104°F / 0°C ~ 40°C |
| Storage Environment | -4°F ~ 176°F / -20°C ~ 80°C |
| Storage Humidity | 35% - 45% |
| Temperature Range | 212°F ~ 932°F / 100°C ~ 500°C |
| Temperature Stability | ± 1°C |
| Noise | ≤ 67dB |
| Airflow Type | Brushless DC Fan |
| Airflow Velocity | 1.5 M/S |
| Air Volume | 31 L/Min |
| Programmable Air Flow | 20-100 |
Weight and Dimensions| Dimensions | 7.0” L x 6.75” W x 6.25” H |
|---|---|
| Weight | 7.5 lbs |
To Next Page
