5. Cautions for installation
■ Make sure to keep the following in mind before installation.
• Installation shall be made on even ground with the car engine turned off.
• Please check the necessary components enclosed in the product kit and follow the installation
instruction step by step.
• This manual describes how to install K11 in a car by car type: passenger car, SUV, bus, and truck.
For buses and trucks, except for the installation position, the procedures are similar with those for
passenger cars. You can find details later in this manual (see page 11).
• After successfully installing the camera, drive on a even, straight road to receive GPS signals (this
will take up to 5 minutes). When you drive over 30 km/h, you will hear a recorded voice ―The Land
Departure Warning System has been calibrated.‖ In re-calibrations another voice message explains
―Recalibration has started.‖ After the voice messages all functions will normally operate.
• If K11 performs incorrectly please reinstall it according to the installation instruction (refer to
page 10).
Caution
9
To Next Page
Loading...
Need help?
General