Xantrex SW3012 User Manual

LITHIONICS BATTERY, CLEARWATER, FL 33759 USA
PH: 727.726.4204 | FAX: 727.797.8046 | WEB: LITHIONICSBATTERY.COM
Lithionics Battery
Xantrex SW3012 Programming Guide
Rev. 0 ©2017 Lithionics Battery
DESCRIPTION: The scope of this document is to provide tested and approved settings for the Xantrex
SW3012 using a Lithionics Battery 12.8V LiFePO4 battery system. Firmware version “3.08.00 BN 9" must be
used which was specifically developed with Xantrex for the SW3012 to work with the more powerful and
much lower internal resistance Lithionics Battery products. Please refer to the SW3012 Owners Guide for
further information on how to install and operate your SW3012 especially the section “Configuring the
Freedom SW using the SCP” Page 33.

Xantrex SW3012 Specifications

General

Brand	Xantrex
Model	SW3012
Category	Camera Accessories
Language	English

Summary

Xantrex SW3012 Programming Guide

Document Scope and Purpose

Provides tested and approved settings for the Xantrex SW3012 using a Lithionics Battery system.

Programming and Configuration Steps

Using the SCP Display/Interface

Select your SW3012 device using the Xanbus System Control Panel (SCP) interface.

Entering Advanced Settings Mode

Enter Advanced Settings Mode by pressing the Enter, Up, and Down arrow buttons simultaneously.

Inverter and Charger Settings Configuration

Input specific Inverter and Charger settings, including battery type, voltages, and charge rates.