14-EN
WORKING HINTS FOR
YOUR CIRCULAR SAW
If your power tool becomes too hot, run it
no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Always use a blade suited to the material
and material thickness to be cut. The
quality of cut will improve as the number
of blade teeth increase. Always ensure the
work-piece is rmly held or clamped to
prevent movement. Support large panels
close to the cut line. Any movement of
the material may affect the quality of the
cut. The blade cuts on the upward stroke
and may chip the uppermost surface or
edges of your work piece. When cutting,
ensure your uppermost surface is a non-
visible surface when your work is nished.
Feeding too fast signicantly reduces the
performance of the machine and shortens
the life of the saw blade. Always face the
good side of the work piece down to ensure
minimum splintering. Only use sharp saw
blades of the correct type.
MAINTENANCE
Remove the plug from the socket
before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a
dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free
of dust. Occasionally you may see sparks
through the ventilation slots. This is normal.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualied persons in order
to avoid a hazard.
TROUBLESHOOTING
1. If your circular saw does not run, check
the plug fuse and power at mains plug.
2. Here are no user serviceable parts in the
saw other than those listed in Care and
Maintenance.
3. If a fault is suspected return to an
authorized dealer to repair.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer
for recycling advice.
To Next Page