xDEEP Ghost User Manual

6 Optional droppable weight pockets
GHOST system enables to install, on the waist strap, xDEEP two-part weight pockets of 2 x 3kg or 2 x 6kg. The
pockets are mounted with bolts to the holes in the central part of the plate:
In order to install the pockets:
1. Remove the buckle and, if necessary, other elements from the waist strap (if installed);
2. Fix the pockets on the waist strap by interweaving the waist strap webbing through proper places in
the weight pockets;
3. With the use of bolts supplied with the pockets, tighten the pockets to the plate through holes in the
pocket webbing and do not forget about the washer.
Attention: In case of special needs, it is possible to install the pockets closer to the buckle. Contact the
manufacturer to obtain more information.
Fig.4. Mount points of two-part weight pockets

xDEEP Ghost Specifications

General

Material	Nylon
Wing Type	Donut
Type	Backplate and Wing System
Wing Lift Capacity	17 kg (37 lbs)
Inflator	K-style inflator
Configuration	Single Tank
Backplate Material	Aluminum or Stainless Steel
Wing Material	Cordura