9 Mounting of the bungee cord 1/2
The STEALTH 2.0 buoyancy compensator is equipped with additional adjustment points used for mounting the
bungee to the compensator which are located in its upper underside. The adjustment points ensure an easy
movement of the bungees at the same time stabilizing the BC and preventing the upper part of the
compensator from getting loose and baggy.
The mounting is achieved by passing the bungee cord through the slit between the strap and the stiff part of
the BC. The compensator is equipped with three mounting points on either side. Depending on the height and
individual adjustment of the harness and bungee cord the user is expected to experimentally choose the most
suitable mounting point out of the three in such a way that the bungee cord goes in straight line between the
mounting point to the harness and the valve of the cylinder.
Improperly installed or worn out bungee cords may cause the separation of the cylinder from the harness.
It is important to check the bungees condition and attachment prior to each dive.
Fig. 8. Bungee mounting points
To Next Page
Loading...
Need help?
General
