– 3 –
XETEC
®
Gravity 8G-1000
Thank you for buying this XETEC product and thank you for your
confidence!
With this XETEC product you have purchased an innovative and
professional high-end product, which will enable you to enjoy your
music on a very high quality level for many years.
We have especially focused on electronics as well as product design to
give you a product that will accompany you for many years, as our products
are always one step ahead remaining modern for a long time. XETEC
products combine our engineers‘ experience with the demands and
ideas of our professional installers.
Please read these instructions very carefully to avoid unnecessary trouble
and defects. In case of trouble, please contact your localXETEC dealer.
The XETEC 8G-1000 is a state-of-the-art 8-channel car audio amplifier,
especially developed for top quality speaker systems and subwoofers. A
perfect choice are the XETEC Component systems and subwoofers.
As a novelty you can also run each set of 4 channels in parabridged
mode to gain 4 times the output power of one single channel, in order
to drive subwoofers, midbasses or high power component systems.
The versatility and many adjustment options make the 8G-1000 an
allround genius for car music reproduction.
Special features XETEC 8G-1000 – State-of-the-art Analog
8-channel Amplifier:
· alu-magnesium diecast heatsink
· 8x130 W
· 2 Ohms stable
· Bridged mode: 4x260 W
· HPAA technology
· TOP control ( all controls accessible under top plate cover)
· Balanced RCA inputs for maximum noise suppression
· Input sensitivity 250 mV – 6 V
· Full protection (DC, Overheat, Shortcircuit, Overload)
· Gold plated input terminals
Possible configurations:
8-ch mode:
8 Channels each with 83 Watts into 4 Ohms or 130 Watts into 2 Ohms
6-ch mode:
4 Channels each with 83 Watts into 4 Ohms or 130 Watts into 2 Ohms
+ 2 Channels each with 260 Watts into 4 Ohms (Bridge Mode)
5-ch mode:
4 Channels each with 83 Watts into 4 Ohms or 130 Watts into 2 Ohms
+ 1 Channel with 330 Watts into 4 Ohms or 520 Watts into 2 Ohms
(ParaBridge Mode)
4-ch mode:
4 Channels each with 260 Watts into 4 Ohms (Bridge Mode)
3-ch mode:
2 Channels each with 260 Watts into 4 Ohms (Bridge Mode)
+ 1 Channel with 330 Watts into 4 Ohm or 520 Watts into 2 Ohms
(ParaBridge Mode)
2-ch mode:
2 Channels each with 330 Watts into 4 Ohms or 520 Watts into 2 Ohms
(ParaBridge Mode)
Safety
· Before you make any connection, the battery must be disconnected!
· A main fuse must be installed into the +12 V wire within the first 12“
from the + terminal of the battery (insurance regulation!).
· Please note that the minimum speaker impedance must be maintained.
Do not connect speakers with lower impedance in normal as well as in
bridged mode or parabridge mode!
· Make sure that you do not use defective speakers and subwoofers.
They can cause damage to your amplifier!
The fuses inside the amplifier only protects the device itself, not the bat-
tery and the car!
To Next Page
Loading...
