XETEC Vector V-150.2 - Page 7

Xetec recommends the following crossover frequencies:
16 cm front speaker : 16 cm rear speaker:
Highpass 80-100 Hz Highpass 100-120 Hz
13 cm front speaker : 13 cm rear speaker:
Highpass 100-140 Hz Highpass 120-150 Hz
10 cm front speaker : 10 cm rear speaker:
Highpass 120-200 Hz Highpass 150-200 Hz
16 cm midbass : Bandpass 80/150 Hz
(= Highpass 80 Hz+ Lowpass 150Hz),
Composystems then are run with Highpass 150-180 Hz!
Subwoofer: Lowpass 70-100 Hz, Subsonic 20-35 Hz
3. Controls
1. RCA line inputs (left and right channels)
2. Gain control
3. Lowpass Frequenz / Highpass Frequenz adjust
4. Power indicator LED
5. Control switch Highpass / Lowpass / Flat ( without crossover )
– 7 –
Vektor_V_150.2_E 13.05.2003 8:21 Uhr Seite 7