Xiamen Rongta Technology Co., Ltd.
www.rongtatech.com 8
Power: 1400 mAH rechargeable li-ion battery
Adapter to recharge: battery can be filled with in 3 hours.
USB to recharge: battery can be filled with in 6 hours.
Notice: The battery to recharge can’t use Adapter and USB at the same time.
A charging time available: Normally, the battery could be used for printing
100meters or 3 hours. The parameter is only for reference; the capacity of the battery
would be decreased after a long time using and could not ensure the actual print time.
IV. Introduction
4.1 Preparing before usage
4.1.1 Battery Installation
1. Pull up the buckle, open battery cover;
2. As shown in the picture, put battery into the battery compartment. Please do
not put the negative and positive poles of battery in wrong way;
3. Then closed the battery cover.
4.1.2 Paper Roll Installation
To Next Page
Loading...
Need help?
General
