8
Cleaning the filter compartment
Note: To avoid damaging the purifier, do not rinse or spray the
purifier directly with water, or wipe it with a soaking wet cloth.
To ensure optimal ventilation and purification, use a
vacuum cleaner to remove any dust from the air inlets
and the filter compartment, or wipe these areas gently
with a soft cloth.
Cleaning the particle sensor
Use a non-sharp tool to open the cover of the particle
sensor, and then use an air blow gun or hair dryer
to clean the filter on the cover and the sensor, as
illustrated in the figure. It is suggested to use a dry
cotton swab to gently wipe the dust adhering to the
sensor every half year.
Note: Do not use hot air.
Warning: Make sure the purifier is turned off and the power adapter is unplugged before performing the following operations.
To Next Page
Loading...
