11
ONOFF
Using the Mopping Function
1. Dampen the mop pad and wring out excess water, then attach it securely to
the bottom of the water tank.
2. Open the water tank plug, add an appropriate amount of clean water, then
close the plug.
Notes:
Do not step on the water tank, as this could permanently damage it.
Heavily soiled floors should be vacuumed prior to mopping for a better result.
Do not use the mopping function on carpet.
Do not use any cleaning agents or disinfectants.
3. Attach the high torque brush bar to the water tank by lining up the magnets
on them until they snap together.
Notes:
The ball valve in the water tank controls how much water is dispensed. The ball
is a moving part and may make a rolling sound when starting and stopping.
This is normal.
When not in use, please keep the switch to the OFF position.
4. This function is designed for vacuuming and wiping down hardwood and tile
floors.
To Next Page
Loading...
Need help?
General
