To Next Page

To Previous Page

Installing the 2-in-1 Charging & Storage Mount

1. The 2-in-1 charging & storage mount should be installed in a cool, dry place with an electrical outlet nearby. Prior to installing, ensure that there are not any wires

or pipes in the space directly behind where the mount will be installed.

2. The bottom of the mounting template sticker should be level and at least 1.03 m from the ground, and its top should have at least 30 cm of clearance above it.

3. Use a power drill with an 8 mm drill bit to drill a hole into each hole marker on the mounting template sticker, then insert a wall plug into each hole.

4. Align the mounting holes on the 2-in-1 charging & storage mount to the holes on the wall, then attach the mount to the wall using the included screws.

Recommended Height: At least 1.03 meters from the ground

The replaceable battery is not

included and purchased separately.

Extended Dock Charging Plate

Extended Dock

Located on the top of the 2-in-1

charging & storage mount and used

for installing the battery pack*. It

supports charging the battery pack

together with the vacuum cleaner.

103 cm

30 cm