6
Cleaning the Filter Assembly
Remove the filter assembly from the dust compartment, then unscrew the filter
from the pre-filter and remove the sponge filter from the filter.
Rinse the dust compartment, pre-filter, filter, and sponge filter under running
tap water until clean, then set aside all parts to fully dry for at least 24 hours.
Do not touch the surface of the filter or sponge filter with a brush or sharp
object to avoid damage.
Do not immerse the filter in water.
* Clean the filter, then rinse it out and lightly tap on the edge of the filter to remove dust and
debris.
Care & Maintenance
Pre-filter
Fliter Sponge Filter
24h
To Next Page
Loading...
Need help?
General
