This version is for private use only and should not be distributed.
06
Troubleshooting
Issues
Can't connect via Bluetooth
Indicator light turns red aer
a firmware upgrade and an error
sound prompt is played
Power buon doesn't respond
Can't run the program
The indicator light doesn't turn
red when charging
The robot can't balance itself
The robot walks shakily
Can't use the app to control the
robot
Can't charge
Possible reasons
The controller's baery is low
The controller is off
Your phone's Bluetooth is off
Bluetooth disconnected
The controller's baery is low
Bluetooth disconnected
You haven't tapped the Start
buon in the app
The power adapter isn't
connected properly
The motor isn't connected properly
The motor isn't connected tightly
The motor is installed in the wrong
direction
The controller's baery is low
The robot isn't assembled properly
Bluetooth disconnected
You're using an incompatible
power adapter
Solutions
Charge the controller
Turn the controller on
Turn on Bluetooth on your phone
Connect via Bluetooth again
Charge the controller
Connect via Bluetooth again
Tap the start buon
Connect the power adapter properly
Connect the motor to the port A or B
Make sure the motor is tightly connected
Make sure the direction of the motor
is consistent with the controller
Charge the controller
Read building instruction to make sure
you've assembled the robot properly
Connect via Bluetooth again
Use a compatible power adapter
Press the Reset buon if you can't solve the issues using the solutions above.
Safety precautions
Avoid disassembling the controller and the motor.
Avoid exposing the toy to sunlight, fire, heat or temperatures above 60°C/140°F.
Do not short circuit.
Avoid any mechanical impact.
Children under 10 years old must be accompanied by adults.
This product is not suitable for children under three years old. Choking hazard.
Toy contains small parts.
The controller must be turned off when it is charging.
To Next Page
Loading...