To Next PageTo Next Page
Need help?Do you have a question about the XICOY FADEC system Autostart 10 and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Operating Temperature | -20°C to +85°C |
| Communication Protocol | CAN bus |
| Compatible Engine Types | Turbine engines |
| Type | FADEC |
Details warranty period, coverage for defects, and the repair/replacement process.
Guides on setting the throttle stick to full power for transmitter calibration.
Guides on setting the throttle stick to the stop position for calibration.
Guides on setting the throttle stick and trim to the idle position for calibration.
Procedure and specific parameters for manual engine starting.
Details requirements and procedures for GAS auto-start operation.
Step-by-step process for initiating and executing the GAS auto-start sequence.
Configures starter power, RPM, and preheat for ignition and fuel ramp phases.
Settings for RPM, pump power, and timeout during the KERO ignition phase.
Step-by-step guide for initiating and executing the KERO autostart sequence.
Explains messages indicating the cause of engine shutdown (UserOff, FailSafe, etc.).
Details warranty period, coverage, exclusions, liability limitations, and claims.
