Need help?Do you have a question about the Xilica Audio Design XP 4080 and is the answer not in the manual?
General| Type | Digital Signal Processor |
|---|---|
| Output Channels | 8 |
| Sample Rate | 48 kHz |
| Category | Audio Processing |
| Analog Outputs | 8 x XLR electronically balanced |
| Input Impedance | > 10 kOhms |
| Frequency Response | 20 Hz - 20 kHz, +/- 0.5 dB |
| Signal to Noise Ratio | >110dB |
| Dynamic Range | >110dB |
| Control Interface | Ethernet |
| Connectors | XLR |
| Power Supply | 50/60 Hz |
| Dimensions | 19" x 1.75" x 8.5" |
USB and RS232 connectors for device interface and communication.
LED indicators for channel status and the LCD display for information.
Buttons and Jog Wheel for navigating menus and adjusting parameters.
Power switch and Ethernet port for device operation and networking.
XLR connectors for audio signal input and output.
Power switch and Ethernet port for device operation and networking.
Euro/Phoenix connectors for audio signal input and output.
Steps to install XConsole software on Windows, including system requirements.
Steps to troubleshoot and establish connection via serial port or USB.
Procedure to view device IP address and network settings within the XConsole software.
Steps for updating the device firmware, including saving data and downloading files.
How to link multiple channels for simultaneous modification using the front panel.
Details on input signal level, polarity, and delay settings.
How to recall stored preset configurations from the device's memory.
To Next Page
