Need help?Do you have a question about the Xilica Audio Design XP 8080 and is the answer not in the manual?
General| Audio Channels | 8 |
|---|---|
| Input Types | Analog, Digital |
| Output Types | Analog, Digital |
| Sample Rate | 48 kHz |
| Network Control | Ethernet |
| Analog Input Channels | 8 |
| Analog Output Channels | 8 |
| Software | Xilica Designer |
| Type | DSP |
| Control | Ethernet |
A standard Type B USB connector for device connection.
A standard female DB9 socket requiring a straight-through cable.
An LED that indicates the currently selected channels.
A mute button for input/output channels; illuminates red when muted.
Indicates the current peak signal level (-12dB, -6dB, -3dB, over limit).
The LCD display shows device information and current settings.
Left and Right buttons used to scroll through device menus.
Left and Right buttons used to scroll through device parameters.
The Enter button confirms actions or enters the System menu.
Exits menus and returns to the home screen.
The Jog Wheel is used to adjust parameter values.
Powers the processor ON/OFF.
Connects the power cord to a 90-240 VAC source.
Connects to the network using a standard RJ45 (Ethernet) Cat5 cable.
Established using Euro/Phoenix 5.08mm type connectors.
Established using Euro/Phoenix 5.08mm type connectors.
Explains how to link channels by selecting multiple input or output channels.
Adjusts input level or gain for mic input (0dB to +45dB).
Configures signal level (-40dB to +15dB), polarity, and delay.
Selects which program to recall from non-volatile memory.
Selects the location in memory to save the program.
To Next Page
