XINDAK XA6950 - User Manual

Questions and Answers

M
michael77Jul 26, 2025
What to do if my XINDAK XA6950 speaker has no sound?
- R
  Rachel NguyenJul 26, 2025
  If your XINDAK Amplifier speaker has no sound, there could be several reasons: * If 'Error-1' is displayed when starting, a DC input may have occurred. Try disconnecting the corresponding input. If it still doesn't work and 'Error-1' is displayed during use, it needs repair. * If 'Vol---' is displayed, release mute. * If the display is flickering and showing a high temperature, the amplifier is in high-temperature protection mode. Shutdown and let it cool down. * Ensure the sound source is open. * Check and replace the signal wire or speaker wire if broken. * Make sure the signal selector switch is correctly tuned to your sound source.
J
Jason CummingsAug 2, 2025
Why is the noise so loud on my XINDAK XA6950 Amplifier?
- J
  jenniferhamiltonAug 2, 2025
  If the noise level is too high on your XINDAK Amplifier, it could be due to: * A high root noise from the sound source. Try using a sound source with a higher Signal-to-Noise Ratio (SNR). * Poor signal shielding. Try changing to a signal wire with better shielding.
B
Bobby ShafferAug 10, 2025
How to fix a XINDAK XA6950 that is not turning on?
- J
  Joseph KingAug 10, 2025
  If your XINDAK Amplifier is not turning on, check the following: * Ensure the power connector is properly plugged in; try re-plugging it. * The fuse may have blown. Replace the fuse with one that matches the specified requirements.
H
Heather SloanAug 18, 2025
What to do if left and right channels are confused on XINDAK XA6950?
- Y
  youngbarbaraAug 18, 2025
  If the left and right channels are confused on your XINDAK Amplifier, it might be because the signal source input phase is opposed. Connect according to the left and right channel indications. Also, check if the speaker wires to the channels have been exchanged or if the positive and negative are reversed.

Summary

Instructions

Important Safety Instructions

Before Use

Special Features of XA6950

Appearance

Front and Rear Panel Overview

Details on the front panel controls and rear panel connections.

Remote Control Unit

Battery Installation and Replacement

Instructions for installing and replacing batteries in the remote.

Connection

Functions and Operating Instructions

Core Operations

Covers power switch, volume control, and signal selection.

Remote Control and Connectivity

Explains remote functions and speaker/input port connections.

Intelligentized Protection

Protection Modes and Error Handling

Details on system protection, error codes, and temperature alerts.

Dimensions

Specifications

General Problems and Troubleshooting

Accessories

Cables and Audio Accessories

Information on Xindak audio cables and accessories.

XINDAK XA6950 Specifications

General

Type	Integrated Amplifier
Frequency Response	10Hz-100kHz (±1dB)
Input Impedance	47kΩ
Weight	23kg
Input Sensitivity	300mV
Dimensions	430mm x 450mm x 120mm
Inputs	4 x RCA
Outputs	1 x RCA (Pre-out), Speaker terminals