Xinje ZG3-30T - Page 48

SD1128
Low 16 bits of current output
frequency(the unit is pulse equivalent)
SD1129
High 16 bits of current output
frequency(the unit is pulse equivalent)
SD1130
Wrong Pulse message
1: Pulse data block error
2:Equivalent mode: pulse
amount/turn, amount/ turn of
movement is 0
3:Code of system parameters block
error
4:Pulse data block exceeds max limit
10:Zero return do not set near point
signal
11:Speed of zero return is 0
12:Crawling speed of zero return is
0
13 Direction of zero return speed and
zero auxiliary speed
SD1131
Code of error pulse block
SD1140
Current segment(No. n segment)
PULSE_8
SD1142
Low 16 bits of accumulated pulse
number (the unit is pulse number)
SD1143
High 16 bits of accumulated pulse
number (the unit is pulse number)
SD1144
Low 16 bits of accumulated pulse
number(the unit is pulse equivalent)
SD1145
High 16 bits of accumulated pulse
number(the unit is pulse equivalent)
SD1146
Low 16 bits of current output
frequency(the unit is pulse number)
SD1147
High 16 bits of current output
frequency(the unit is pulse number)
SD1148
Low 16 bits of current output
frequency(the unit is pulse equivalent)
SD1149
High 16 bits of current output
frequency(the unit is pulse equivalent)
SD1150
Wrong Pulse message
1: Pulse data block error
2:Equivalent mode: pulse
amount/turn, amount/ turn of
movement is 0
3:Code of system parameters block