Xinje ZG3-30T - Page 49

error
4:Pulse data block exceeds max limit
10:Zero return do not set near point
signal
11:Speed of zero return is 0
12:Crawling speed of zero return is
0
13 Direction of zero return speed and
zero auxiliary speed
SD1151
Code of error pulse block
SD1160
Current segment(No. n segment)
PULSE_9
SD1162
Low 16 bits of accumulated pulse
number (the unit is pulse number)
SD1163
High 16 bits of accumulated pulse
number (the unit is pulse number)
SD1164
Low 16 bits of accumulated pulse
number(the unit is pulse equivalent)
SD1165
High 16 bits of accumulated pulse
number(the unit is pulse equivalent)
SD1166
Low 16 bits of current output
frequency(the unit is pulse number)
SD1167
High 16 bits of current output
frequency(the unit is pulse number)
SD1168
Low 16 bits of current output
frequency(the unit is pulse equivalent)
SD1169
High 16 bits of current output
frequency(the unit is pulse equivalent)
SD1170
Wrong Pulse message
1: Pulse data block error
2:Equivalent mode: pulse
amount/turn, amount/ turn of
movement is 0
3:Code of system parameters block
error
4:Pulse data block exceeds max limit
10:Zero return do not set near point
signal
11:Speed of zero return is 0
12:Crawling speed of zero return is
0
13 Direction of zero return speed and
zero auxiliary speed