Need help?Do you have a question about the XIRO Xplorer G and is the answer not in the manual?
General| Manufacturer | XIRO |
|---|---|
| Category | Drones |
| Model | Xplorer G |
| Weight | 1.2 kg |
| Flight Time | Up to 25 minutes |
| Max Range | 500 meters |
| Max Speed | 15 m/s |
| Battery Capacity | 5200 mAh |
| Operating Frequency | 2.4 GHz |
| GPS | Yes |
| Follow Me Mode | Yes |
| Return to Home | Yes |
| Video Resolution | 1080p |
| Charging Time | 90 minutes |
Use the latest gimbal and flight control firmware versions for calibration.
Place aircraft horizontally, power on devices, and press IOC, Home, Auto-Take off/Landing buttons.
Roll down both control wheels for 2 seconds, then release to initiate the calibration.
Ensure gimbal is in Power Off state; camera should not adjust when touched.
Fix gimbal with clamp, then press IOC, Home, Auto-Take off/Landing buttons to finish.
Power off aircraft and controller, then remove the gimbal clamp.
Power on devices and check if the gimbal is correctly positioned horizontally.
To Next Page
