EasyManua.ls Logo

XK A300 User Manual

XK A300
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Question and Answer IconNeed help?

Do you have a question about the XK A300 and is the answer not in the manual?

XK A300 Specifications

General IconGeneral
BrandXK
ModelA300
CategoryToy
LanguageEnglish

Summary

Product Introduction and Specifications

Aircraft Features and Modes

Details the aircraft's EPP material, motor, remote control feel, 6-axis gyro, and various flight modes.

Basic Parameters and Configuration

Lists wingspan, length, weight, material, battery, and remote controller specifications.

Packing List

Installation Procedure

Install the upper wing

Attach the upper wing to the fuselage using screws, aligning locating posts.

Install the lower wing

Attach the lower wing to the fuselage, securing with screws and connecting wiring.

Install the left and right wing struts

Attach the wing struts to the left and right wings, securing with screws.

Install Wing Trims and Landing Gear

Install Left and Right Wing Trims

Install decorative trims in the middle of the left and right wings, aligning holes.

Install Front and Rear Landing Gear

Install the front and rear landing gear into the designated slots on the wing and fuselage.

Assemble Tail Surfaces and Blades

Assemble Flat Tail and Vertical Tail

Thread vertical tail wire, align and install flat tail, then attach vertical tail and secure.

Assemble Propeller, Fairing, and Trim

Install propeller, fairing, and wing trim, securing parts with screws and adhesive.

Frequency Matching

Aircraft Control Surface Adjustment

Adjust Vertical and Horizontal Tails

Adjust vertical tail and horizontal tail surfaces to the neutral position for correct flight.

Takeoff Procedures

Ground Takeoff

Steps for performing a ground takeoff, including wind placement and throttle/lift control.

Hand Throw Takeoff

Describes correct and incorrect methods for hand-throwing the aircraft for takeoff.

Landing Procedure

Flight Mode Selection

3D/6G Mode Switching

Explains how to switch between 6G stability and 3D stunt flight modes.

End Flight Procedures

Battery Removal and Safety

Emphasizes removing the battery after flight to prevent damage and fire hazards.

Propeller Replacement

Component Replacement

Replacing Fairing and Motor

Instructions for replacing the aircraft's fairing and motor, detailing screw removal and installation.

Remote Control Overview

Component Identification

Identifies the different parts and controls of the remote controller for both modes.

Transmitter Battery Installation

Remote Control Functions

Alarm Sounds and Throttle Unlock

Explains various alarm sounds and the process to unlock the throttle for takeoff.

Left/Right Hand Control Setup

Details how to switch the remote control between left-hand and right-hand throttle configurations.

Frequency Matching Guide

Pre-flight Preparation Steps

Charging and Pre-flight Adjustments

USB Charger Usage

Instructions on how to use the USB charger to safely charge the aircraft's battery.

Pre-flight Adjustments and Checks

Details checks for control surface neutrality, deflection, motor operation, and center of gravity.

Receiver Connections

Flying Operation Guide

Control Button Functions

Light Control Button

Describes the operation and modes of the aircraft's light control button.

6G/Senior Mode Operation

Explains the 6G/Senior manual mode, gyroscope deactivation, and recommendations for use.

Troubleshooting Common Issues

Important Reminders and Skills

Ground Takeoff Techniques

Provides specific techniques for a successful ground takeoff, including wind placement and control inputs.

Anti-loss and Low Battery Alarms

Explains the anti-loss function and low battery alarm system for enhanced flight safety.

Related product manuals