To Next PageTo Next Page
Need help?Do you have a question about the XLPower Specter 700 V2 and is the answer not in the manual?
Guidelines for safe operation, including location, conditions, and pilot responsibilities.
Assembly of main blade grip, bearings, washers, and thrust bearings.
Attaching the main blade grip arm with ball studs and screws.
Installing head dampeners, spindle, and applying silicon grease.
Assembly of swashplate upper, outer, inner parts with bearings and cover.
Attaching the main shaft collar and securing the main shaft.
Assembling the radius arm and control arm with ball bearings.
Connecting titanium main rotor linkage and servo rods.
Mounting main shaft bearing blocks and spacers.
Attaching servo mounts and frame spacers to the upper frame.
Installing anti-rotation bracket and rear canopy mount.
Attaching carbon fiber plate and front belt idler mounts.
Mounting servo horns and carbon servo washers.
Adjusting servo washers for optimal clearance and operation.
Installing battery tray rails and the center plate.
Attaching battery tray guides to the lower carbon frame.
Installing the right tray guide and quick release battery system.
Mounting the front canopy mount with frame spacers.
Finalizing the front canopy mount attachment with specific screws.
Attaching the landing gear mounts and struts.
Installing the skid pipes onto the landing gear assembly.
Mounting the servo motor onto the helicopter frame.
Attaching the tail boom and tail case with bearings.
Installing the tail pulley, grub screw, and tapered end tail shaft.
Mounting the vertical fin and rear belt idler pulley.
Assembling tail pitch levers, control arm, and support.
Connecting tail pitch assembly, slider bearing, and control links.
Installing tail grip, center hub, bearings, and thrust bearing.
Assembling the tail damper and spindle into the tail grip arms.
Mounting the main gear and one-way bearing hub.
Installing the 100T front pulley and routing the drive belt.
Adjusting the main shaft collar for zero pitch.
Setting belt tension by adjusting the tail boom and case.
Assembling tail pushrod ends and connecting the control rod.
Mounting the tail control arm and rod guide for centering.
Mounting the motor and installing the pinion gear.
Assembling the lower motor mount and carbon fiber brace.
Setting the gear mesh between the pinion and main gear using paper.
Mounting ESC plate, support block, and rubber caps.
Installing the battery tray V2 and puller mechanism.
Assembling AS150 connectors, housing, and quick connect mount.
Solder ESC/battery wires and mate AS150 connectors.
Assembling SupraX S7 connectors, housings, and insulator caps.
Solder ESC/battery wires and mate SupraX S7 connectors.
General
