Need help?Do you have a question about the XLPower Specter 700 and is the answer not in the manual?
Lists essential technical specifications including dimensions, ratios, weight, and battery tray size.
Details safe operating procedures for the helicopter in various environments and conditions.
Outlines essential checks before adjusting and operating the model for safe flight.
Lists essential RC components such as ESC, servos, transmitter, receiver, and battery pack.
Specifies necessary tools like screwdrivers, thread lock, and grease for assembly.
Illustrates the main blade holder, ball bearings, and washers used in its assembly.
Details the assembly of the main blade holder arm, including balls and screws.
Shows the installation of head dampeners, spindle, and related components.
Illustrates the swashplate parts, including upper, outer, and inner plates with bearings.
Guides the installation of the main shaft, emphasizing correct hole positioning for proper function.
Details the assembly of control arms and radius arms with pins and screws.
Shows the installation of titanium main rotor linkages and servo rods with attention to thread direction.
Illustrates the assembly of the belt tensioner, including pulley, mounting block, and reinforcement.
Details attaching the belt tensioner reinforcement and carbon fiber main frame.
Guides the installation of plastic servo mounting blocks and servo horns.
Illustrates the pre-assembled main shaft bearing block and third bearing block with angular contact bearings.
Details the attachment of servo mounts (up and lower) and canopy mounts to the frame.
Shows the installation of front and rear tail boom clamps onto the frame.
Details the assembly of the right side carbon fiber main frame and belt tensioner components.
To Next Page
General
