Xo BAR PRO - Installing Front Components

To Next Page

To Previous Page

INSTALLING THE XO FRONT COMPONENTS

1. Located the supplied hardware bag

2. Install the two stainless steel shoulder screws into the right hand side inserts of the front panel.

3. Carefully lower the bottle holder on the newly attached shoulder screws.

4. When installing the bottle opener you will need to Install the third shoulder screw directly below the far le

insert. Attach the top of the bottle holder when you install the towel bar, as they share the screw.

5. Continue to install the towel bar using the second stainless steel phillips head screw provided.