- 30 -
2. safety and information
2.2 product inspection
Each unit of this product is checked before leaving the factory.
Customers receiving the inverters should however check that:
1. The correct model has been delivered.
2. There is no damage caused by transport. If there is, do not turn on the inverter.
1. Product installation and use must comply with the standards in force.
2. Installation and maintenance must be performed by qualified personnel who have read this booklet.
3. If the motor overheats in an abnormal manner, immediately close the water supply valve and discon-
nect the electrical power supply and contact the service centre or the dealer. Do not start the electrical
pump until the problem is resolved.
4. In case of malfunction, immediately close the water supply valve and disconnect the electrical power
supply and contact the service centre or the dealer.
Do not start the electrical pump until the problem is resolved.
5. Make sure to keep this product away from children and take all necessary precautions so that they do
not come into contact with the equipment.
6. The product must be positioned in a fresh, dry and ventilated environment with room temperature.
7. Ventilate premises when too hot and prevent condensate, which may cause electrical failures, from forming.
CAUTION
2.3 information regarding environmental conditions
The conditions of the environment in which the inverter is installed affect its operating duration.
Therefore make sure the following conditions are met:
> The product must be used indoors at a temperature between -10 C° ~ +40 C°;
> The premises must well ventilated and not humid, away from fuels and radioactive materials;
> Make sure there is no electromagnetic interference caused for example by dust, fine metals and fabrics.
GB
To Next Page
Loading...
Need help?
General