XPower X-2000 Series User Manual

English - 15
Troubleshooting Guide
*/** The additional electrical receptacle / GFCI function does not apply to all models
mentioned in this manual (See Page 16: Technical Specifications).
If troubleshooting does not resolve your problem, please contact XPOWER or other
parties authorized by XPOWER for further instructions.
PROBLEM POSSIBLE CAUSE SOLUTION
Air Scrubber does
not start
No electricity. Check for power supply.
The power cord is not properly
plugged in.
Remove and reconnect the
power cord.
The circuit breaker on the
additional electrical receptacle
(Daisy chain)* trips.
Remove all appliances on
the additional electrical
receptacle and press circuit
reset button.
Unit runs but no
or very low air
movement
Air outlet is blocked. Remove blockage.
Filters are fully loaded. The
filter change light illuminates.
Clean or replace the loaded
filters. (See Page 11: Filter
Maintenance)
The additional
electrical
receptacle has no
power*
The circuit breaker on the
additional electrical receptacle
(Daisy chain)* trips.
Remove all appliances on
the additional electrical
receptacle and press circuit
reset button.
A ground fault causes power
interrupt by GFCI**.
Turn off and unplug the
Air Scrubber. Remove all
appliances on the additional
electrical receptacle and
press GFCI reset button.
The Test Button
doesn’t react to
GFCI test based on
the maual

XPower X-2000 Series Specifications

General

Brand	XPower
Model	X-2000 Series
Category	Air Cleaner
Language	English