14
Caution:
1. Data debugging mode print all need 4 "wide label paper
2. Shut off the power to jump off the debug mode, return to normal print mode or
press the FEED button to return to the standby state
4.3.3 Printer initialization
The printer initialization function is to clear the memory (DRAM) download files,
and print parameters to restore the factory settings.
Please do the following steps：
1. Power off
2. Press the paper key and turn on the power. The power indicator below color
cycle
Indicator color cycle mode:
Blue and purple
Blue
Blue and purple
Red(flashing 5 times)
Blue and
purple(flashing 5 times)
Blue(flashing 5 times)
Blue
(fixed)
3.
When the power indicator is blue flashing release paper key will reset the
printer, then the power indicator will flash a purple, finally the power indicator is
blue ready state.
The printer configuration will be restored to the default after initialization：
parameter Default value
speed
101.6 mm/sec (4 ips) (203DPI)
76 mm/sec (3 ips) (300DPI)
concentration
8
Label width
4” (100 mm)
Label height
7.9” (180 mm)
Sensor type
Gap sensor
Gap setting
0.16” (4.0 mm)
Print direction
0
reference point
0,0 (upper left corner)
Offset
0
Tear-off mode
On
character
850
Country code
001
Clear Flash
No
IP address
DHCP
To Next Page
Loading...