17
5.2 Printer settings
1. Select the connection interface between the computer and the printer.
The default communication interface for this
printer diagnostic utility program is USB, so
if you are using a USB line to connect the
computer to the transmission, this part does
not have to change its settings
2. Pressed the "printer" in the function setup。
3. The printer features in the printer settings management page are as follows。
Function Description
Calibrate Sensor
Calibrate the sensor specified in the Printer
Setup group media sensor field
Ethernet Setup
Setup the IP address, subnet mask, gateway
for the on board Ethernet (Please refer to next
section)
RTC Time Synchronize printer Real Time Clock with PC
Factory Default
Initialize the printer and restore the settings to
Reset Printer Reboot printer
Print Test Page
Print a test page
Configuration Page
Print printer configuration
Dump Text To activate the printer dump mode.
Ignore AUTO.BAS Ignore the downloaded AUTO.BAS program
Password Setup Set Printer password when used.
To Next Page
Loading...