Xprinter DT108B Series - Correction of Paper Sensor with Printer Diagnostic Tool

To Next Page

To Previous Page

5.3 Correction of paper sensor with printer diagnostic tool

5.3.1 Auto Calibration

1. Make sure the paper is installed correctly and the print head is closed。

Note: this type of paper sensor is not adjustable, please confirm the gap position paper

2. Printer power supply。

3. Open the Diagnostic tool and setup interface (default is USB)。

The default communication interface for this

printer diagnostic utility program is USB, so

if you are using a USB to connect the

computer to the transmission, this part does

not have to change its settings

4. Press press Calibate key。

5. Select the type of paper and press the "Calibrate" button, the printer will

automatically feed movement sensor calibration。

Gap sensor

Paper sensor