FLEX
FIXED
When using xed bushing, tighten fully.
INITIAL SETTING
When using the ex bushing, tighten the screw fully and then
loosen 1/4 of the turn to allow movement of the top deck.
7. FUEL TANK & ELECTRONICS
3x6
➊
➋
➌
➌
Use an appropriate receiver battery pack
The RX8 accommodates standard 5-cell receiver
packs or optional micro-size packs.
Attach steering linkage
to servo saver
Tighten fully
ASSEMBLED VIEW
Use tape to mount the receiver
battery pack to the lower holder
(not included).
Antenna
3x8
2x6
DETAIL
Servo arm must be perpendicular to
linkage when servo is in neutral
90°
Personal Transponder
(not included)
Receiver (not included)
Battery (not included)
THREAD LOCK
Route servo and transponder leads into
box and seal with silicone sealant.
If the receiver box has 2 different-size openings for
cable entry (narrow and wider), cut away the tab for the
appropriate opening to allow the cables to t properly.
3x6 (servo saver)
3x8
3x8
3x12
902306
SH M3x6
902312
SH M3x12
902308
SH M3x8
902306
SH M3x6
902308
SH M3x8
907206
2x6
903306
SFH M3x6
To Next Page
Loading...
