Need help?Do you have a question about the Xray X1 and is the answer not in the manual?
General| Brand | Xray |
|---|---|
| Model | X1 |
| Category | Motorized Toy Car |
| Language | English |
Contact information and resources for assistance with the RC car.
Essential safety guidelines to prevent injury and damage during assembly and operation.
Key considerations for building and operating the RC model.
Critical electrical safety guidelines for wiring and battery handling.
Practical advice for successful assembly and setup of the RC car.
Details on product warranty coverage and limitations of liability.
List of essential tools needed for building the RC car kit.
Overview of parts included in the kit and those that must be purchased separately.
Instructions for sanding and sealing graphite parts for durability.
Step-by-step guide for assembling the front upper suspension arms.
Instructions for assembling the front lower suspension arms.
How to adjust the car's wheelbase for different handling characteristics.
Setting up standard and wide track-widths for front tires.
Using eccentric bushings to adjust the front caster angle.
Utilizing eccentric bushings to set the front camber angle.
Choosing and installing appropriate front coil springs for track conditions.
Setting the rear pivot position for optimal steering and traction.
Adjusting the rear roll center using shims for improved handling.
Configuring the rear pod linkage for stability and steering.
Installing and adjusting side springs for traction and cornering.
Modifying chassis flex using braces for different grip levels.
Adjusting rear ride height and orientation with eccentric bushings.
Step-by-step instructions for building the ball differential.
Selecting and installing shock pistons for desired damping.
Procedure for correctly filling and bleeding the center shock.
Setting and verifying the shock absorber's rebound characteristics.
Adjusting the center shock length for rear downstop control.
Configuring the steering arm and pivot shaft for optimal steering.
Installing the servo saver and selecting appropriate aluminum servo horns.
Connecting the steering servo to the steering assembly.
Setting the rear wing height for aerodynamic tuning.
Choosing battery placement for desired weight distribution and handling.
Steps for cutting, painting, and mounting the car's body and front wing.
To Next Page
