8
WHELLBASE ADJUSTMENT
By changing the position of the front suspension
on the chassis, you can change the wheelbase by
+/-4mm.
VERY IMPORTANT
When setting the wheelbase all the mounting
positions on chassis and top deck must be same.
When using middle position as initial setting, all
mounting positions on chassis and top deck must
be in the middle.
STANDARD (INITIAL SETTING)
As an initial setting use the middle holes for
standard wheelbase.
LONG
The long wheelbase is recommended for high-
traction tracks or large, open tracks. The long
wheelbase makes the car turn smoother, improves
stability, and makes the car easier to drive.
SHORT
The short wheelbase is recommended for low- to
medium-traction tracks or smaller technical tracks.
The short wheelbase improves steering and rotation
of the car.
STANDARD
TOP DECK
LONG
SHORT
902306
SH M3x6
LOWER ARMS
The adjustable backstops are used to limit the steering angle.
Adjust the backstop with the set-screw to achieve the maximum
steering angle needed. Adjust the steering angle on both L & R
sides to the same amount.
BACKSTOP
STEERING ANGLE
1.5 mm
DETAIL
The top deck setting must be always
identical with the wheelbase setting
on the chassis.
2x
1. FRONT SUSPENSION
I recommend using 27° of steering angle for most conditions. If you use more, the car
stops too much; only on very small & technical tracks does it make sense to use more.
PRO TIP to check the angle: Take a look from the top of the car on full steering. The tire
angle should be parallel to the upper wishbone.
Jan Ratheisky
(Factory Driver)
To Next Page
Loading...
