9
902306
SH M3x6
902306
SH M3x6
903308
SFH M3x8
903308
SFH M3x8
303123
SHIM 3x6x2
303123
SHIM 3x6x2
2mm
2mm
10.8mm ALU STAND
10.8mm ALU STAND
2mm
2mm
(INITIAL SETTING)
These shims adjust the roll-center of the front bottom arm as well as the front ride height. The
thickness of the shim depends on the tire diameter. For initial setting, use the 3x6x2mm shim.
IMPORTANT!
Use the same shim thickness under all 4 posts.
These shims adjust the roll-center of the front bottom arm as well as the front ride height. The
thickness of the shim depends on the tire diameter. For initial setting, use the 3x6x2mm shim.
IMPORTANT!
Use the same shim thickness under all 4 posts.
STANDARD TRACK-WIDTH
ALTERNATIVE 1
Standard track-width setting is used for standard F1
front tires such HUDY, RIDE, HOT RACE.
To make sure that you use the correct setting,
measure the track-width with the tires; the track-
width must be maximum 190mm.
2x
WIDE TRACK-WIDTH
ALTERNATIVE 2
Wide track-width setting is used for the narrow F1
front tires such as Volante.
To make sure that you use the correct setting,
measure the track-width with the tires; the track-
width must be maximum 190mm.
2x
DETAIL
DETAIL
INITIAL SETTING
The 2.5mm chassis made from harder graphite
material was developed for very-high traction
conditions, or when using tires that offer a lot
of steering which makes the car more difficult
to drive. This chassis makes the car more
stable and easier to drive, and eliminates
oversteering.
#371027
GRAPHITE CHASSIS - HARD - 2.5mm
1. FRONT SUSPENSION
To Next Page
Loading...
