Need help?Do you have a question about the Xray XB2 and is the answer not in the manual?
General| Drive System | 2WD |
|---|---|
| Shock Absorbers | Oil-filled |
| Motor Type | Brushless |
| Battery Type | LiPo |
| Radio System | Not Included |
| Scale | 1:10 |
Details the XB2C'24 & XB2D'24 Edition and provides a general product overview.
Provides pre-assembly advice, kit requirements, and general operational guidelines.
Offers contact details for support and links to online resources and community.
Outlines essential safety rules for building, operating, and handling the model.
Highlights specific warnings related to electrical components, wiring, and battery safety.
Explains the product warranty terms and limitations of manufacturer liability.
Lists all necessary tools and specialized equipment needed for building the model.
Details parts included in the kit and essential equipment needed for operation.
Provides guidance on servicing drive shaft pins and preparing graphite parts.
Step-by-step instructions for assembling the gear differential for carpet surfaces.
Step-by-step instructions for assembling the ball differential for dirt surfaces.
Procedure for breaking in and fine-tuning the ball differential for optimal performance.
Detailed instructions for assembling the rear gearbox and associated drivetrain components.
Guide to assembling rear suspension arms and adjusting geometry with eccentric bushings.
Installation of anti-roll bars and rear roll center components for chassis tuning.
Assembly of rear uprights and selection of appropriate wheel hubs for track conditions.
Instructions for assembling the front chassis section and lower arm mounts.
Guide to building front suspension arms, blocks, and steering linkage.
Details on installing C-hubs and adjusting the caster angle for steering response.
Overview of shock parts, springs, and selection of piston types and sizes.
Step-by-step guide for shock building, filling, and setting suspension rebound travel.
Installation of servos, motor, speed controller, and receiver onto the chassis.
Instructions for mounting the front anti-roll bars onto the chassis.
Securing the battery pack and adjusting its position for optimal weight distribution.
Guide to cutting, painting, and attaching the Lexan body and wing to the chassis.
Fitting the wheels, tires, and aerodisks to the completed chassis.
Routine checks and procedures for refilling and bleeding shock absorbers.
Proper methods for cleaning and lubricating ball bearings to ensure smooth operation.
Regular inspection of suspension parts, drive shafts, and gears for wear and damage.
To Next Page
